江门市云顶电玩城精密机械有限公司-专业生产金属密封配件

VCR接头安装的详细步骤-江门云顶电玩城精密机械技术分享

[导读]:安装前要确保TUBE管连接端的表面没有缺陷(无凹陷、凸起或刮痕等),端面经切割和平口成90度,并且去除了管内外毛刺。  Before installation, ensure that the surface o···

安装前要确保TUBE管连接端的表面没有缺陷(无凹陷、凸起或刮痕等),端面经切割和平口成90度,并且去除了管内外毛刺。

  Before installation, ensure that the surface of the TUBE connection is free from defects (no dents, bumps, scratches, etc.), that the end face is cut to 90 degrees from the surface of the mouth, and that the internal and external burrs of the TUBE are removed.

222.jpg


VCR接头安装步骤:


  (1)需要连接的VCR组件。

  (2)分别将外螺纹螺母(Male Nut)和内螺纹螺母(Female Nut)套在接头(Gland)上,然后分别同需要连接的TUBE管自动焊接。

  (3)安装金属垫片:如果是带爪垫片,将垫片卡在Gland上(注意不要划伤Gland的密封面);如果是无爪垫片,将垫片放进Female Nut内。

  (4)用手指拧紧内、外螺母。

  (5)用记号笔在内、外螺母的六角头上划线做记号(如图6)。

  (6)用一个扳手固定外螺纹螺母,另一个扳手向内拧紧内螺纹螺母1/4圈(即90度)。

  Installation steps of VCR connector:

  (1) VCR components that need to be connected.

  (2) Male Nut and Female Nut are respectively set on the Gland, and then they are automatically welded to the TUBE to be connected.

  (3) install metal gasket: if it is with claw gasket, clip the gasket onto the Gland (pay attention not to scratch the Gland sealing surface); If it is a claw less washer, insert the washer into the Female Nut.

  (4) tighten the inner and outer nuts with fingers.

  (5) mark the hexagon head of the inner and outer nut with a marking pen (as shown in FIG. 6).

  (6) use a wrench to fix the nut with outer thread and another wrench to tighten the nut with inner thread 1/4 turn inward (i.e. 90 degrees).

33.jpg

文章出自江门云顶电玩城 转载请标明出处

VCR接头订购联系:秦先生 17688183787


  • 首页
  • 新闻
  • 案例
  • 电话咨询